Drinking Water Defluorinate 2-3mm Activated Alumina for Water Purifying Agent

Our company adheres to the development strategy of internal management and external market, and wholeheartedly creates the latest and best new HPA For Phosphor Coating, Alumina polishing slurry, aluminum oxide desiccant adsorbent for the majority of new and old customers and provides the most satisfactory service. We have established a correct business philosophy, developed diversified businesses on the basis of specialization. Only by creating value for customers, can we create value for ourselves. Our company takes customer demand as the center and provides professional, intimate and efficient service to customers.

Production Introduction

Activated alumina water treatment produced by Avant can be used as high fluoride (fluorine removal ability) of drinking water defluoride agent, defluoride agent, and deacidification agent of transformer oil.

It is used as a drying cycle for the regeneration of oxygen industry, textile industry, electronics industry, alkylbenzene production of alkane gas, etc.

There are several ways to remove fluorine: 

(1) Membrane Method; 

(2) Flocculation Precipitation Method; 

(3) Ion Exchange Method; 

(4) Adsorption Filtration Method.

The main factors affecting the adsorption performance of water treatment activated alumina:

(1) Particle size: the smaller the particle size, the higher the adsorption capacity. But the smaller the particle size, the lower the particle strength;

(2) PH value of raw water: the lower the PH value, the higher the adsorption capacity of it;

(3) Initial fluorine concentration in raw water: the higher the initial fluorine concentration, the higher the adsorption capacity;

(4) Alkalinity of raw water: the concentration of bicarbonate in raw water is high, and the adsorption capacity is reduced;

(5) chloride ion and sulfate ion;

(6) Arsenic: water treatment activated alumina also has an adsorption effect on arsenic in water.

The accumulation of arsenic on it causes a decrease in the adsorption capacity of fluoride ions, and it is also difficult to wash out the arsenic samples during regeneration.

Specification

Al2O3	≥92	≥92	%
SiO2	≤0.10	≤0.10	%
Fe2O3	≤0.04	≤0.04	%
Na2O	≤0.30	≤0.30	%
Bulk density	≤0.75	≤0.75	g/ml
Surface area	≥320	≥320	m2/g
Pore volume	≥0.40	≥0.40	ml/g
Crushing strength	≥30（1-3mm）	≥60（1-3mm）	N/Granule

Product feature and application

Water treatment activated alumina defluorination is the most common method and the most successful method. Because of its high adsorption capacity, good strength, wear resistance, long service life and stable performance, the water quality after defluorination meets the hygienic standards set by the state, so it is one of the indispensable water purification materials for sewage treatment. In sewage treatment, it is a porous adsorbent, which has mechanical strength, physical and chemical stability, high temperature resistance and corrosion resistance. In particular, it has a good effect on the treatment of fluorine-containing wastewater.

Product qualification

 

Function

It has selective ability to absorb water in gases, water vapor, and some liquids. After adsorption and saturation, water can be removed by heating at about 175-315℃ and resurrected. Adsorption and resurrection can take place multiple times. In addition to being used as a desiccant, it can also absorb the vapor of lubricating oil from polluted oxygen, hydrogen, carbon dioxide, natural gas, etc. It can also be used as catalyst, catalyst carrier and chromatographic analysis carrier. Al2o3 belongs to the category of chemical alumina, which is mainly used as adsorbent, water purifier, catalyst and catalyst carrier. According to different USES, its raw materials and preparation methods are different. Aluminum oxide under certain operating conditions and regeneration conditions, the product drying depth up to the dew point temperature -70 degrees below.

We will constantly satisfy our respected customers with our good excellent, superior value and superior assistance due to we're additional experienced and far more hard-working and do it in cost-effective way for Drinking Water Defluorinate 2-3mm Activated Alumina for Water Purifying Agent. Our company promises: reasonable prices, short production time and satisfactory after-sales service, we also welcome you to visit our factory at any time you want. Our employees have undergone long-term technical training and are professional technical consultants to ensure that a reasonable, efficient, energy-saving and economical plan is designed for customers.

Hot Tags: Activated Alumina Water Treatment, China, manufacturers, suppliers, factory, wholesale, price, gas depth drying, Reforming Continuous Reforming Dual Multifunctional Metal Catalysts CCR , CAS 1344 28 1, 25BSP Aluminum Hydroxide, gas separation unit adsorbent media, Activated Alumina Drinking Water Defluorination